OP
- Thread Starter
- Thread starter
- #781
You made those obstacles look pretty easy! I've been over a few of those and they are definitely much more scary and difficult in person!
What did you do to your Bronco Raptor today?
- Thread starter Dragoon
- Start date
Roughstock
Well-known member
Getting ready for Foutz Rear lower arm frame guards. A bit of emery cloth and some flat black paint I had kicking around I am pleased with the outcome. Looking forward to protecting it.
Added the TUFSKINZ FORD letters in velocity blue. Really like it on the Code Orange. Im going to do all the Raptors in the velocity blue. Really pops with the code orange plus i have the blue interior.
Turbo yzel
Well-known member
- Dec 3, 2022
- 552
- Gallery
- 495
- 1,055
- Current Ride
- Ford Bronco Raptor
- Current Ride #2
- Jeep Cherokee Trailhawk
- First Responder
- 27 yrs SAR, Wilderness EMT, retired
Turbo yzel
Well-known member
Is that the OEM winch mount?
- Dec 3, 2022
- 552
- Gallery
- 495
- 1,055
- Current Ride
- Ford Bronco Raptor
- Current Ride #2
- Jeep Cherokee Trailhawk
- First Responder
- 27 yrs SAR, Wilderness EMT, retired
No. It is a Rough Country high winch mount (PN 51067).
OP
- Thread Starter
- Thread starter
- #788
The approach angle on that mount looks about perfect!
Did you air down any for these trails or did you keep the pressures up for for clearance?
- Dec 3, 2022
- 552
- Gallery
- 495
- 1,055
- Current Ride
- Ford Bronco Raptor
- Current Ride #2
- Jeep Cherokee Trailhawk
- First Responder
- 27 yrs SAR, Wilderness EMT, retired
The RC winch mount does not impact the OEM approach angle of 47°. When I was at the 43° wall obstacle, Poison Spider, the mount never touched the wall; even with a 1.5" fairlead and F55 flatlink.
I was aired down to 20-22 psig on all obstacles and trails.
OP
- Thread Starter
- Thread starter
- #790
Have you considered going up to the 39-inch KO2s when you wear out the stock tires or are you content with the capabilities of the 37s?
- Dec 3, 2022
- 552
- Gallery
- 495
- 1,055
- Current Ride
- Ford Bronco Raptor
- Current Ride #2
- Jeep Cherokee Trailhawk
- First Responder
- 27 yrs SAR, Wilderness EMT, retired
When I bought the
Raptor, I was/am pretty proud of saying ". . . other than that, it's completely stock." No changes to suspension, steering, engine or drivetrain; all the important stuff.Short Answer: for about 2 seconds
Long Answer: 37" KO2s are heavy enough to move around, 105-lbs mounted. I would probably cuss lifting a 39" mounted tire onto the spare carrier. The 37s give the
Raptor an average ground clearance of 14 inches. So far, I've found that to be sufficient for up to a hard 7 trail. Ask me again after I do some 8s. If I change anything, I'll probably go from the C rated 37s to a D rated 37 for better sidewalls. E rated might be too much?I saw a lifted truck with 44" tires on the Golden Spike. It required a step ladder to get into the cab. Sure, it rolled over every obstacle like it wasn't there, but what's the fun in that? Besides, it needed to be trailered everywhere.
Bigger is not always better. Best to go with stock and learn better skills.
OP
- Thread Starter
- Thread starter
- #792
I can attest to the stock spare already being a royal PITA to remove and mount! The only way I can justify the 39s is going with a lightweight wheel like the RTR's. If you go that route I think the weight difference is pretty negligible considering the diameter improvement.When I bought the
Short Answer: for about 2 seconds
Long Answer: 37" KO2s are heavy enough to move around, 105-lbs mounted. I would probably cuss lifting a 39" mounted tire onto the spare carrier. The 37s give the
I saw a lifted truck with 44" tires on the Golden Spike. It required a step ladder to get into the cab. Sure, it rolled over every obstacle like it wasn't there, but what's the fun in that? Besides, it needed to be trailered everywhere.
Bigger is not always better. Best to go with stock and learn better skills.
Turbo yzel
Well-known member
I was able to make mine fit on the alignment rack today
91” wide now
91” wide now
Turbo yzel
Well-known member
I was also able to finish installing more of the Foutz Motorsport ‘s protective skid plates
The frame sliders, and the shocks skids
Along with the previously mounted differential cover
The frame sliders, and the shocks skids
Along with the previously mounted differential cover
Turbo yzel
Well-known member
Also popped on the new 40” sticky mickeys 
Are these 13.50? Look like 40 pizza cutters on the alignment rack.Also popped on the new 40” sticky mickeys
Either way, these make me want to jump up in size where I’ve previously been debating dropping to 35s.
Turbo yzel
Well-known member
OP
- Thread Starter
- Thread starter
- #798
It looks amazing! How's the road noise with these tires?Also popped on the new 40” sticky mickeys
I have the rtr with 39 ko2s and it is about the same weight as the stock beadlock capable and 37 ko2s. ko2s are actually one of the lightest tires in their size. I have no issue taking off/ putting on my spare. its actually lighter than i thought it would be. I do live in the gym though 
- Dec 3, 2022
- 552
- Gallery
- 495
- 1,055
- Current Ride
- Ford Bronco Raptor
- Current Ride #2
- Jeep Cherokee Trailhawk
- First Responder
- 27 yrs SAR, Wilderness EMT, retired
Wt. Delta = 16 lbs/each
Cost Delta: $673 vs $418
BFG comparison to Nitto and Falken.
I suppose if you went to a bigger rim, like 20", then you could reduce the weight some. But then you need new rims.
Last edited:
